Interested to Buy Any Domain ? << Click Here >> for more details...
Main Differance between Primary Distribution & Secondary
Distribution Of Electricity....?
- 1 Answers
- 24840 Views
- I also Faced
- E-Mail Answers
Answer Posted / sukhraj singh
primary distribution - Electric power is distributed among
bulk power consumers at 33KV or 11KV.
Secondary distribution - Electric power is disributed among
small poer consumers at 400/230V.
| Is This Answer Correct ? | 59 Yes | 5 No |
Post New Answer View All Answers
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
what is die electric strnth of transformer ?
Does the direction of rotation of d.c. Shunt motor would get reversed if the armature current and field current both are reversed?
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
33kv substation lay out details & line to line & line to earth measurements
Which do you think is the most significant cause of energy loss in a factory?
Why an ac systems are preferred over dc systems?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
tell me about roaster switch .& what is the function in transmission & distribution?
who invented active elements? plz give me the complte details of active elements...
How will you define capacitance?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
2. What are the parameters of EHT sub-station?
