Interested to Buy Any Domain ? << Click Here >> for more details...
Why DC current is not used in transformer?
- 20 Answers
- 41729 Views
- JK Paper, TCS, I also Faced
- E-Mail Answers
Answer Posted / elango.k
In dc the rate of change of flux is zero .when dc is
applied to primary windings there is no back emf to oppose
the supply voltage . the winding acts as resistance -where
high current flow through the coil and transformer is burnt.
I=V-Eb/R
Eb-BACK EMF
V- DC SUPPLY
I- CURRENT IN PRIMARY
R- RESISTANCE OF COIL(small)
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
what is PDU in transformer?? which company manufacture??
how to commissioning the genset with amf panel?
ow can i get certificate of competency as electrical supervisor and my diploma in electrical engineering from jalgaon.
hi I have done 3 yrs diploma in electrical engg after 10+2. I have 16 years of work experience into design proposals sales and engg application development in LV/MV swithcgear and sub station automation field. I want to apply for immigration to new zealand but I am not sure whether I qualify or not since I dont have a degree. Can anyone advice? Thanks Riz
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
how to calculate the breaking capacity of different breakers.
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
how to carried out DAR test in 11 KV Alternator ?
Classify drilling machines.
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
why and how current drawn by battery charger depends upon the altitude where it is located?
What happened when capacitor connect series in ac circuit?
