Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / arvind
you can use 10nos of blades, but if u use 10 blades then
motor required to rotate these blades will be of higher
rating means higher is the cost, if you purpose is served
by 2 or 3 blades then why anybody waste his/her money
unnecessary
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
what is the write prosidure of stringing of 8meter pcc pole.
what is the thumb rule for determination resistance of resistor?
what is the principle of operation of CFL ??
what are factors to be consider to design a HT & LT motor?
what is mean by drives?
why r we using shell transformer for low voltage
How phase displacement change in the over current relay coils.
how choose conductor&depending upon load
Why is the frequency not changed during transformation of electrical energy in a transformer?
What is the basis for framing the rules of block diagram reduction technique?
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
please give some hindalco placement papers for written exam
Why efficiency of generator is higher than motor at a particular load?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
What is the most important precaution in any experiment with d.c. Shunt motor?
