Interested to Buy Any Domain ? << Click Here >> for more details...
Why I-section is preferred to channel section?
- 7 Answers
- 19489 Views
- Engineers India, I also Faced
- E-Mail Answers
Answer Posted / himanth kumar
The C/s of a member is used effectively only when the MI on
both X & Y axis are equal.
for I-Section in is nearly equal when compared to the C-
section.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
How do you measure water flowing through 300mm diameter pipes?
How high should the water tank be to provide a 60 psi at base of this water tower?
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
what is spacing of wallar support of 3m column. the thickness of column is 0.25 m.
What is passive earth pressure ?
Minimum and maximum size of the building components
How does siphoning work?
quantity of sand and cement for 10m2 plastering 10mm thick for the ratio of 1:4,1:3and its leabour data
importance of the soundness test to determine the quality of cement use for any construction
what is the difference b/w full length and cutting length?
How to find the cuplock pipe qty in staging for Minor bridge?
What is OSHA compliance?
plz.show development and anchorage length in simple diagram.
What is high adherence steel bar? I have a general specification which refers to High Adherence steel bars, coils and meshes to BS EN 10080 and BS 4449 or BS 4483. Is this just general re-bar or is there something different about it? The spec originated in France.
Rate analysis of 150mm, 100mm, & 230mm thk BBM work
