how we select the fuse and OLR rating for 3 phase
induction motor from 1HP TO 100 HP?
Answer Posted / ranjan behera
rating of fuse=175% of full load current.
| Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
what irequirment need to be followed when working on live equipment
What are the material used for resistor?
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
why we can use 1 to 5V dc
What is super thermal power plant? and how it will differ from normal thermal power plant
Convert a star connected network into a delta connected network.
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
i have applied for junior engineer 2 c&w for Guwahati RRB please send me last five year question paper
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
WHAT HAPPENED DC SERIES MOTOR FIELD WINDING OPEN. CAN POSSIBLE.
how to setting voltage RTCC panel
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
Why the efficiency of generator is more than motor in swinburne's test
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer