what is difference between total flow and flow rate in
general ?? explain it with daily life example.
- 3 Answers
- 21259 Views
- GNFC, I also Faced
- E-Mail Answers
Answer Posted / suresh
TOTAL FLOW= AREA OF ANY CONTAINER X HIEGHT WILL BE TOAL
FLUID GOT INTO CONTAINER
FLOW RATE= D.V.A
WHERE D= DIA OF PIPE
V= VELOCITY OF FLUID
A= AREA OF PIPE
| Is This Answer Correct ? | 6 Yes | 13 No |
Post New Answer View All Answers
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
Question on maha cement
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
Describe the function of Accumulator into the Pump
What is zener diode? What is voltage regulator?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
how is work pressure switch& level switch?what is the principle of this?
flow transmeter accuracy 0.075% of full scale & find ucertainty is 0.025 % so what is maximum limit band of uncertainty
What is the difference bitween control net scaner and device net scaner
Reason for capillary type dp level transmitter fluctuation
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
How to Calibrate Interface Level Troll in field
