Answer Posted / bhigesh
its problem of pf variation
Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
why there using acb enclosure in big buildings
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
how much GROUND & NEUTRAL VOLT maintain in data center.
What is acsr cable and where we use it?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
how to calculate power consumption in slip ring motor at different step
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
how we sesign the transformer give some specifion regarding design of transformers
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
What is meant by impedance? difference between high & low impedance ?
How stabilizer works??