Interested to Buy Any Domain ? << Click Here >> for more details...
what is cogging and crawling
- 20 Answers
- 85153 Views
- ABB, Ashok Leyland, Bharat Bijlee, BMRCL, MN Dastur, Siemens, I also Faced
- E-Mail Answers
Answer Posted / vsanth palkaran
what u mean by cogging it is nothing but it is depend upon
the current when we never give the load cogging is not
happen in the motors to avoid the cogging just switchoff
the supply THANK YOU.
Crawling means muttil ezhayuva this is not a problem it is
a habit............veendum thank you
| Is This Answer Correct ? | 4 Yes | 41 No |
Post New Answer View All Answers
When will you multiply and devide with derating factors to the actual value while sizing the cable?
In what condition the HT fuse breakes?
we need a ntpc previous papers
what is the relative size of single and three phase?
how you configure motorvision relay (L&T make)from DCS
Post possible questions for Power Factor Panel FAT / SAT
how to decide no of electrodes for 1600A LT Main incomer panel
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
What kind of maintenance is conducted for Transformer
What is the difference between Static and servo controlled voltage stablizer?
how harmonics generated in induction furnance? how minimise it?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
