Answer Posted / arvind

current capacity is depend on current and how much current
capacity do you want to take.

How much no load current of synchronous motor

1593

---

how to calculate the formula of cable size if motor kw is given

1688

---

Can u Explain about the electronic trivector meter and the use of data converters in them?

1889

---

The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?

1172

---

What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines

1276

---

---

Iwould like to know barc interview questions

2654

---

can the measured percentage error during calibration of single phase energy meter be negative?

1924

---

In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)

1306

---

what is stper motor

1986

---

high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...

1540

---

we need a ntpc previous papers

1449

---

what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking

1447

---

I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA

2532

---

What mean by MLTP

3430

---

what is meant by tranformer impedance?

2156

---