Interested to Buy Any Domain ? << Click Here >> for more details...
How can we calculate the fault level of the distribution
system knowing the percentage impedance of transformer &
subsequent equipments.
- 14 Answers
- 60076 Views
- I also Faced
- E-Mail Answers
Answer Posted / mukul
Dear friends above answer is wrong when you are using
transformer KVA in you calculations then pf is not required
the above answer can be corrected by omitting pf from this calcs
| Is This Answer Correct ? | 44 Yes | 5 No |
Post New Answer View All Answers
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
What is the end effect of linear induction motor ??
Difference between rating factor of cable and derating factor of cable?
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
l&t switch FN 63 handle position can we change
What do you mean by dependent and independent voltage sources?
If one lamp connects between two phases it will glow or not?
What id difference between power and energy?
for what purpose the star point is done in ct
what are the factors to be considered while design the breaker either HT or LT??
how to failure indution motor insulation & how to improve heat in motor insulation
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
