Generally at what power factor the electronic equipments
like computer, TV, EPABX etc.,operates. Please tell me.
- 1 Answers
- 3350 Views
- HAL, I also Faced
- E-Mail Answers
Answer Posted / guest
Generally close to 1, say 0.95, as oposed to for example,
motors.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
which types of relay used in acb and vcb?
What is the effect of pi controller on the system performance?
why ht cable end termination don't have a gland?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
when elecromagnatic waves are propogated in a wave guide?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
What is the capacitance values of 132,220,400 & 765 kV current transformer
which type of cabel
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
What is the difference between Droop vs Isoch Control?
how to calculate earth fault relay current and CBCT ratio
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
