Interested to Buy Any Domain ? << Click Here >> for more details...
What is the formula for converting Pipe Diameter to Plate?
- 5 Answers
- 28339 Views
- I also Faced
- E-Mail Answers
Answer Posted / aniket shyam shewate
measure the outside of Pipe and multiply it by 3.14 n you
will get the plate i.e.developement length
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
If 320 grade Gear oil is used in a reduction gear box,what can be themaximum operating temperature of the gear box?
thermal engg
describe a type when u anticipated potential problems and development of preventive measure.
Q. what @the interview exact Q&A is it correct
explain the omportance of "squish" and "swirl" in ci engine
why we r recommended for pre-action sprinklers @ generator/tx/mv panel room. If any leakage there,that panel will damage. So what is the Logic for pre-action sprinklers there?
What is extruded aluminium used for?
Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?
Hello, I am PRAVEEN, working with start-up company as design, I don have any sap experience. but I wanted to join mm course in atos. Is it good change domain?
How the thickness of thermal boundary layer and thickness of hydrodynamic boundary layer related ?
Why the work per kg of air flow in axial flow compressor is less compared to centrifugal compressor for same pressure ratio ?
What is the purpose of increasing the pressure on the F.O. system of the engine?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
what is fullform of ge 9ea gas turbine
What is the use of divider?
