Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / haridass
Friends, plz understand the question first. The
interviewers has mentioned "how to calibrate a NEW i/p
converter?"
Why the new i/p needs calibration?
Your answer must be like this..
"Sir, the new i/p would be factory calibrated with high
accuracy master instruments, so before we commission it in
the plant we have can check its output by applying proper
signal, unless we have good accuracy masters we no need to
disturb the calibration. If yes, we can do the calibration
using the 30psi regulated supply, 4-20 mA source, and
receiver gauge."
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
Explain the working of an enraf level gauge.
what is KV and XV valve
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
what is the reason while warning lamp is on while the engine is cranking?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
i need some objective type questions in instrumentation
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
