Which supply is using for train AC or DC & what is the
voltage????????
Answer Posted / annu
IN INDIAN RAILWAY 25000V SINGLE PHASE AC SUPPLY IS USED
WHICH IS CONVERTED IN D.C THROUGH A RECTIFIER SET BECAUSE
IN ELECTRIC ENGINE WE ARE USING DC SERIES MOTOR AND FOR
THIS WE NEED DC SUPPLY . CAUSE OF USING DC SERIES MOTOR IS
THAT ITS STARTING TORQUE IS TOO HIGH IN ALL MOTORS.
| Is This Answer Correct ? | 80 Yes | 1 No |
Post New Answer View All Answers
can we use trip light with bus coupler?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
what is meant by class 1 E in electrical power supply?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Name two low frequency oscillators?
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
where can the transformer having vector group Yny0 be used??
Is electro plating what type of load whether resistive, inductive or capacitive loads
what is the cause of voltage dipp or swell in the transmission lines?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
why co incidence factor considered in transformer sizing?
earth also having a gravitational force (magnetic field of north and south)but it attracts any object compare to this theartifical magnetic cant perform same as earth why?
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
How does the phase sequence controller works, how it identifies the phases? confirm working principle