Answer Posted / dharmendra
In transformer both winding are connected magnetically.Also
on same limb.No air gap between primary and secondary.
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
What is nyquist contour?
is it possible to have dc motors on single chip
any one please tell taht what type questions will be asked in BHEL interview, i am having interview on 24th Dec, please send this to mail pradeepsistam@yahoo.co.in
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
What do you mean by a current transformer?
Who are the manufacturer for Nitrogen based Fire Protectio/explosion prevention for Oil Filled Transformers? India and international both?
How to convert 2 phase to 3 phase electricpower in induction moter?
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
SUTIABLE FOR ohm's law super conductor
Load break swicth maintenance procedure.
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
how could we know the size of cable by physical view?
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?