Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / yash
transformer do not rotate because it has conentrated
winding, not distributed as in case of motor, which are
displaced by 120 degrees.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
why we use 630mm single core cable for transformer secondary side and why two neutral cable
how to compare with Relay settings for HT< panels, RMU panel, and PSS CSS transformer?? 1) Load amps, 2)Tripping time, 3) CT ratio, 4)Cable size 5) Transformer KVA rating 6) transformer full load amps
What is the formulae of Megger value for a A.C.Motor
What is core CT & it's function?
WHAT IS ELECTRICAL MAINTAINTENCE ?
For R-L or R-C ckt,time constant formula is L/R and RC respectively and its unit is in sec.Pls tell me the derivation
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
What is the purpose of stablization resistor in high impedance bus bar protection
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
What is the distance between each insulator in 33kv transformer and how can it calculate
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
do you have some of interview Questions in power and genrator section in general whith answers
What are reasond for high wattage in single phase induction motors
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
reason of diode failure in alternator
