Interested to Buy Any Domain ? << Click Here >> for more details...
what r the types of transmission line?
- 28 Answers
- 52961 Views
- DIET, RRB, WAPDA Water and Power Development Authority, I also Faced
- E-Mail Answers
Answer Posted / pankaj kumar gupta
Short transmission line
medium transmission line
long transmission line
| Is This Answer Correct ? | 21 Yes | 3 No |
Post New Answer View All Answers
what shoud be strength and weakness to impress interviewer????????
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
how to know the diffrential relay setting of 06mva step- down (delta-star)transformer?
How to know of any cable size if there are not written on cabl?
Explain what are inter-poles and why they are required in a dc machine.
what is difference between 2 pole structure and 4 pole structure in transformer yard
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
How may I enrol or get admission to your program?
What is resonant frequency?
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What is slope...? Explain slope 1 and slope 2...?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are approaches to tackle sedimentation problem of reservoir?
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
