what is the difference between isolation and insolation ?
please explain in detail with example.
- 5 Answers
- 22645 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / alok & kapil
Insolation is a measure of solar radiation energy received
on a given surface area in a given time. The name comes
from a portmanteau of the words incident solar radiation.
It is commonly expressed as average irradiance in watts per
square meter (W/m2) or kilowatt-hours per square meter per
day (kW·h/(m2·day)) (or hours/day). In the case of
photovoltaics it is commonly measured as kWh/(kWp·y)
(kilowatt hours per year per kilowatt peak rating).
isolation- isolation means to isolate or sepsrate two live
electrical parts .
| Is This Answer Correct ? | 5 Yes | 8 No |
Post New Answer View All Answers
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How is the connection of the tap changer on the HV side been made?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
Discuss about gear cutting machines.
What is earth?
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
I have 1500/1A CT If i connect this CT in 6.6KV bus bar means what will be the voltage present in CT?
What is meant by stator? What is meant by rotor?
WHAT IS START TO INDUCTION MOTER IN STAR TO DELTA OF >5HP ?
How we can come to know the substation range,without go through any name plate ?
List few applications of d.c series motor?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
a starter used for squirrel cage induction motor?
