Answer Posted / mahendra s

Hi friends

The diffenrence is simple " In electrical the objective or
aim of the technology is to scaling up the parameter that
is very high voltages and current but in electronics the
technology is to scaling down the parameter say voltage and
currenrt"
we have heard that the transmission voltages are in kv,mv
region only is to increase the efinciency ,quality of power
trasnfer, but bigger is size ex:transformer,towers.circuit
breakers,motors etc
but in electronics to do same thing,they go for very low
voltages say milli volt,higher frequency thats why the
componenets are very small ex: Ic,diode,transistors etc

how to decide the capacity of accl

2490

---

What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?

2051

---

What is the technical difference between On delay timer and a Star delta timer?

1677

---

CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor

1700

---

How to calculate the phase to phase clearness of HT /// LT bus bar?????

2136

---

State the points to be considered for selecting a particular type wiring.

2128

---

How to calculat the ratio of HT\LT in energy meter

2756

---

how the CT and PT is connected in the circuit during testing of transformer explain with diagram

2068

---

r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā

1764

---

i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.

1852

---

3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??

1462

---

what is integrated ac contact circuit

2135

---

why swinburnes test cannot be performed on series machines?explain

2397

---

How to calculate earth wire load by formula

2634

---

HOW TO CALCULATE THE VT SIZING?

3214

---