Interested to Buy Any Domain ? << Click Here >> for more details...
Which standard is used for calibration of Control Valves ?
- 2 Answers
- 7729 Views
- I also Faced
- E-Mail Answers
Answer Posted / earnest
0.2 bar - 0%, 0.4 - 25 %, 0.6 - 50 %, 0.8 - 75% and 1bar -
100%
| Is This Answer Correct ? | 18 Yes | 0 No |
Post New Answer View All Answers
What is the use of temprature compensation?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
steps for installing orifice plate?
what are the diff. in servo and regulatory control?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
What is instrumentation measurement?
Differentiate between ultrasonic flowmeter and radar type flow meter
what is piezoelectric transducer?give an example in power plant n state its principle?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
Draw a group of instruments interlocked to a Pump & Motor?
State some of balance principle’ advantages?
What is the procedure of calibration of Load cell?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
How to convert Differential pressure to flow in TPH
How u measure the massflow in orifice flow measurement techniques
