WHAT IS THE difference betwwen LT CABLE AND CONTROL CABLE
- 5 Answers
- 7048 Views
- I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
LT cables ratings are interms of few KVA t0 several hundred
KVA but control cables from few VA to hundred VA
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
full form of electrical?
how to find Harmonics and types as per the equipemnts
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
How to test Alternator stability test for REF relay
How many gap between finger contact in a.c.b. and v.cb.?
What are the basic properties of signal flow graph?
Dear sir, my knowledge about cable size determination is limited. Though I read examples I could not calculate the Cable size required for electric driven pump 40 KW, 380 Volt, 50 HZ, 50 meter from transformer and it is three phase star delta starting. Please help as there is no one in my surroundings to help.
what is resver in electrical enginnering with answer
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
how we provide neutral earth on synchronising panel as per electrical standards?
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
