Interested to Buy Any Domain ? << Click Here >> for more details...
In which type of circuit short circuit is dangerous in
parallel or series and why?
- 6 Answers
- 10212 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajib
Series ckts are effected more than parallel.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is the resistance of the field winding of a d.c. Shunt generator kept low?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
What is the Minimum winding resistance of motors ( small & big)? referance range
why tertiary winding is used in transformer with diagram?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
how to check three phase motor torque value?
What is use of starter and choke in tube light
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How will be the single line diagram of series trip HT breaker? how it works?
What is the abbreviation of NGT panel
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
