You have to design a machine component. For what type of
failure (ductile or brittle) you will design?
- 9 Answers
- 12924 Views
- DRDO, I also Faced
- E-Mail Answers
Answer Posted / kumar suman saurabh
basically machine component design for brittle failure will
surely be safe for ductile mat bcoz in ductile mat stress
conc and fatigue is not as critical as in brittle mat...so
we should design for brittle failure which ultimately will
safeguard a ductile failure but it will add to economy and
fall under overdesign category.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
What are whiskers ?
previous question papers for group 2
How is ceramic defined ?
What causes damage to impellers?
How cavitation can be eliminated in a pump?
Define Fluidised bed boiler ?
DAE Mechanical engineering interview questions
What is the profile of QA engineer
Which pipes are used for steam lines?
what is tranformer and transducer
What are considerations taken into account while creating a piston head?
Difference be betwin Fe-500 as per IS 226-1975 & IS 2062-2006
Is it required slip & guide for incliened pipe installation to allow axial expansion. If yes, what type we have to use it
hello i have a problem !!!! i am studying gait analysis"human walking; and i had only single camera"sony 25 frames/s" and 2 separated force plates, and there is no synchronization between the camera and the force plates!. i wrote a matlab program to calculate joints moment(sagital) using inverse dynamics methode. and there is a problem with the output data!! can you help me.
Hi any one can help in preparing for BHEL ET exam in mechanical stream? I like to know the the question paper pattern fro the same. regards, Jose 9841327666 josevinoth@yahoo.com
