Interested to Buy Any Domain ? << Click Here >> for more details...
What is Single Phasing fault???(not single-phase fault)
- 6 Answers
- 17621 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / abhishek (balco)
if 1 phase is out then machine works with two phase with
heavy losses. it takes very high current..
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
which network topology offers the greatest level of tolerance?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
my diploma certificate in my higher education college
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
CBCT selection
define the active power?
different aspects of voltage stability
what is differentila pilot supervision in the incomer control panel in the power station?
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
what is meant by 2 within a star in a voltmeter dial?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
why and how voltage sharing in transformer, during magnetic balance test ?
what are the 4 rules to start the motor?
