Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between electrical & electronics
- 245 Answers
- 349837 Views
- Axon Constructions, Banking, GDA Technologies, Infosys, MBA, Satyam, Satyam Tech, Snow White, TCS, I also Faced
- E-Mail Answers
Answer Posted / anbarasu
electrical is power . but electronics is base of atom. we
can use "atom based equipments" require power because of
move a free electron.so electrical is a power but
electronics is equipment. but we could say high voltage
equipment are called electrical, low voltage equipment are
are called electronics.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
tell me about eletrical contractor
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
What are the common sources of energy?
what is droop control?
What is the high series capacitance winding on high voltage power transformer ?
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
Describe Non I.S. Earth System and why is it used?
List the advantages of star-delta starter with induction motor?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
Define active filter?
what is ground fault in ACB?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
How to Prepare preventive maintenance shedule of machine tool.
