Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between electric and electronic circuits?
- 11 Answers
- 27683 Views
- I also Faced
- E-Mail Answers
Answer Posted / vilas
Electrical circuit generally deals with more than 24 volts
consist mainly power circuit and control of ,relays,
contactor,motors ,load component.Whereas the electronic
circuit deals with voltage lower than 24 volts, consists
diodes, resistors, transistors,plc,and electronic
controls,+48 and -48 volts in the electronic
telecmmunication,with high frequency,
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
why sielent pole is used only in hydro generators and not in turbo generators
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
What if the difference beween internal and exrteranal LBB?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
how to synchronize 3 phase slip ring induction motors of different ratings.
List examples of current sources?
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
Hello sir i m student of gtu .what is idp.
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
How to know of any cable size if there are not written on cabl?
