what is power factor? how can we correction the power factor
if this is high or low? If anyone know please please send
the answer on my email id ( kumarkirshan@in.com )
Answer Posted / naresh
The accurate defination is it is the angle between
Fundamental voltage & Fundamental current. we can calculate
the fundamental components from fourier transform.
in case of linear load(resistor,capacitor,inductor)
we can improve it
1.by connecting capacitor loads
2.using Synchronopus condensor(overexcited synchronous motor
under noload condition)
3.by using Power Factor Correction Unit
in case of non linear load(containing
converters,inverters,rectyifiers)
1.by adjusting the delay angle,extinction angle
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
State the formula for overall efficiency of thermal power station
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
Which power will flow first if we switch on a motor Active or Reactive? How?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
Should power factor be low or high?
What is knee point voltage of transformer?
why ct ,cvt should be stored in a vertical position?
What is s-domain and its significance?
draw 3 phase rectifier diagram
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?