Why Instrumentation Air Compressor called as
Instrumentation Air compressor?pls dont just tell its
trasferring IA to all transmitter,valves.I need exact
reason, please......................
Answer Posted / abhishek vyas
Basically in organization there diffrent pressure required
say 6kg/cm. sq. to 16 kg/cm.sq. for diffrent purpose so
utility area has configure their compressore as per
pressure required ,6kg/cm.sq pressure is the basic
requirement for control valve,actuator etc so that
compressore is called instrument air compressore which is
producig 7.0 kg./cm. sq. taking the fact in considaration
of Air savig and power saving.
Is This Answer Correct ? | 2 Yes | 11 No |
Post New Answer View All Answers
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75
The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is:
WARNING: Could not connect to equalize destination. (7001)
Retrying. Number of retries = 0/1
ERROR: LdXopsLoadMain: connect error 10060
ERROR: Processing terminated due to connection error. (7002)
Equalization end with errors. STN0149
---- ERROR = 2 WARNING = 1 ----
Background:
>Updated the ExaOPC software on the STN from 3.60 to 3.75
>STN operating system is Windows Server 2008 R2
>HIS operating system is Windows Server 2016 Stanard
Solutions attempted include:
>Ensuring all IP addresses are correct and all networked devices can be pinged.
>The ability to ping a device using its host name from another device (
Capacitance, resistance ( colour coding ), parallel & series circuits.
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
what is the difference between active & reactive power?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
what is the procedure of belt scale calibration?
sir, give me placement papers and interview quistion of birla group company of copper.
what is function of sensor, and how is it work , explain with difination
What is stripper & spilitter ? Diffrence in this.?
Why plc require in analog input 4-20amp & 0-10 volt?
What is the cascade control
how u calibrate pneumatic n motorized c/v?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
What are the interlocks we have to check during the start up of LP/HP compressor?