Interested to Buy Any Domain ? << Click Here >> for more details...
hi am durga, i just now completed my eie [2009] , can
anyone please guide me what r courses i need to join to
enter into core company
- 6 Answers
- 8269 Views
- I also Faced
- E-Mail Answers
Answer Posted / gowrishankar
nothing u have to do plc & scada then only u get a job easily...if u any doubt ,mail me..good luck
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
Explain the use of hair spring in the pressure gauge.
what can of fault ofently come in vibration mesurement?
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
Decibel.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
In Safe Guarding test what means by "Failed to Danger" ?
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
How to calibrate H2s Dectector
In which principles tx ,pressure gauge,Temp gauge,control valve works?
How u will setup SPI(2007) on Citrix Server (Thin Client Mode)? Plz Justify?
