what type of protection used below 132KV feeders
- 11 Answers
- 20717 Views
- APTransco, Telecommunications, wbsedcl, I also Faced
- E-Mail Answers
Answer Posted / santosh kawade
Following protections are used for feeders below 132KV:
1) Over current protection (normal inverse and
instateneous),
2) Earth fault protection (Normal inverse curve),
3) Horm 4 protection (feeder protection),
santosh kawade
9224 69 3116
| Is This Answer Correct ? | 37 Yes | 4 No |
Post New Answer View All Answers
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
Do you need any help with FEWA Electrical Supervisor exams?
How to calculate the sag on transmission Lines.
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
how many stairs have you climbed while you were coming
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
hai...... tis is Hemanth. jst now completed electrical engineering... i wanna to apper for ap tranco exam... plzz send me the previous q's paper link......thanx in advance.
How can we calculate the motor frame sizes?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
How to calculate VCB rating for 33KV ,25 MW Power line?
