WHY WE NOT USE 2-20mA,1-20mA,3-20mA or 10-50mA SIGNAL?
INSTEAD OF 4-20mA.
- 6 Answers
- 14247 Views
- Hindustan Unilever Limited, Yashmun Engineers, I also Faced
- E-Mail Answers
Answer Posted / anil
starting with 4ma is to know DEAD or LIVE of the
transmitter,4 to 20 is used for linearty and according to
ohms law to covert 1 to 5 volt dc,
| Is This Answer Correct ? | 19 Yes | 4 No |
Post New Answer View All Answers
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
this site is owned by an nonsense
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
where cascade loop use ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
Question on maha cement
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
send me last 5 years questions asked in rrb chennai, for section engineer
