What will happen if we give DC supply to AC motor?
Answer Posted / nitin, s.u.k.
When we apply a d.c. source to a a.c. motors then a steady
magnetic field is developed in stator which does not
produce a rotating magnetic flux to rotate the rotor.
Is This Answer Correct ? | 5 Yes | 6 No |
Post New Answer View All Answers
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
what are the principles of a booster converter?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
What is the difference between AC and DC injection methods for rotor earth fault protection
how to test reverse power trip?
What is meant by Load Encroachment in OHL Feeder Protection?
How many types of circuit loads are there in a common electrical circuit?
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
The electromagnetic torque developed is proportional to what in a D.C series motor?
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.