Interested to Buy Any Domain ? << Click Here >> for more details...
How Humming noise generated in starter motor which was used
the start the engine in a vehicle/car/Truck?.Moreover
Starter motor was operated in DC power supply. Can you guys
clarify ?
- 2 Answers
- 6760 Views
- I also Faced
- E-Mail Answers
Answer Posted / 1802.pranav
actually in stater of a vehicle there is one solenoid switch
which has one auxiliary and one main winding.so as soon as u
rotate the key of car,auxiliary winding comes into the
picture and 1st contact is made.in this situation motor runs
at low speed around 600rpm.But when 2nd switch comes into
contact due to main wdg then motor runs at max speed.and
when 2nd switch comes into contact it produces spark and
pushing action DUE TO WHICH HUMMING SOUND COMES.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
which type of motor is used in automatic swing gate
What will be the effect if I use inverter as UPS mood?
hi frds, i m electrical engineer.can i get cdr for electrical engineer if u have then send me on my mail id its jayesh_ee88@yahoo.com.please help me frds
Refernce currents are to be generated using refernce cueernts how can this be done??
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
How you calculate the repturing capacity of a HRC fuse
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
trasnfarmaer core make
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
power transmission pole used one support , that only for support or earthing
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
