Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / alianwar
A Light Emitting Diode lamp is a solid state lamp (SSL)
that uses light-emitting diodes (LEDs) as the source of
light. Since the light output of individual light-emitting
diodes is small compared to incandescent and compact
fluorescent lamps, multiple diodes are used together. LED
lamps can be made interchangeable with other types, but the
presently at a higher cost. Most LED lamps must also
include internal circuits to operate from standard AC
voltages. LED lamps offer long life and high efficiency,
but initial costs are higher than for flurorescent lamps.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
why the India electrical supply transmission loss is high when compare to us
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
What is marx circuit?
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
What is the main purpose of c.f.b.c.boiler
Starting current of a 10 HP induction Motor is ______ time’s full load current.
are there rmu for 3 transformer?
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
what is alluminium arm in ab conductors
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
Which capacitor is preferred for high voltage and frequency?
