Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference when selecting a cable between AC
and DC current?
- 13 Answers
- 54916 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rms
In selecting a cable it is based on the rms (root mean
square) value of the current. The fact is that rms value
produces the same amount or almost equal of energy like that
dc.
20A of dc= 20A of AC rms...
| Is This Answer Correct ? | 15 Yes | 8 No |
Post New Answer View All Answers
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
how to calculation increase power factor for single phase
can we synchronize star system generators with delta system generators?
plz send me the syllabus or any sample paper for engineer trainee recruitment if any,on ravinder911@yahoo.com
why zero sequence impedance measurement is not applicable for single phase GT
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
define digital electronic
what is the effect of power factor of machines in starting current
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What mean by MLTP
What is the difference between a Root Locus plot and a Bode plot?
How to back charge the Gas turbine generator
How servo stabilizer works.
What is hipot test procedure?
