I want to measure bidirectional steam flow? Kindly suggest
me a suitable flow meter. steam is superheated at 41kg/cm2,
350°C
- 2 Answers
- 5748 Views
- I also Faced
- E-Mail Answers
Answer Posted / guru
bi-directional Averaging Pitot Tube,Transit Time Ultrasonic
Flow Meters.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
What is frequency factor in massflow meter? When using frequency output?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
NSV type probe stands for
How is PH sensor works ?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
How to erection of DCS Panel at site step by step
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
Why even multiple power supplu r used in instrumentation system?
detail of mass flow meter pricipal
whatis range of marcury filled tempereture gague
What is the reason PT speed not incresed in gas turbine?
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
