Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bhavini
bucholz relay is the protection relay for internal fault
occures in oil filled transformers
any gaseous generated due to winding temp. should be high
oil form in gaseous.
there have two floats first 4 alarma nd 2nd for trip
command
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
Do closed loop systems require manual input?
How does PLC work for sychronising of Two or more DG sets?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is the function of auadag in a cro?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
what is the difference between 4pole & 6pole DC Motors & give advantage ?
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
What is the difference between hot and cold loop testing?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
Why negative feedback is preferred in the control system?
how to calculate percentage impedence at 75 deg C at normal tap
