Interested to Buy Any Domain ? << Click Here >> for more details...
why motor starting current is High ?
- 11 Answers
- 24622 Views
- Bhel, Jindal, I also Faced
- E-Mail Answers
Answer Posted / tawfiq
when we turn on a motor,it induces a relatively high
current to get over the inertia of the motor. this induced
current is estimated to be 7*rated current if the motor was
in direct to line connection
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
size of condotory fron voltage level
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
What are the different towers used in 132kv transmission line? what are the differences between the P,R,S towers used in 132KV and detailed explanation
what do u understand about FACTS? how they are useful?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
How to calculate or formula to calculate rhe power in 2 phase system ??
What is an automatic controller?
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
Why do we require transformer with less specific weight if supply frequency is increased?
what is the function of statics switch in ups and tell me parts
How can you sized or estimate the ligthning arrester current rating?
What is the limitation of kirchoffs law?
3phase cable calculation formula by motor load
