Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pradeep bhadouria
safety measure of alternator are
a) over current relay
b) over voltage and under voltage
c) reverse power relay
d) low frequency
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
What is the effect of positive feedback on stability of the system?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
Capacitor is load free component but why ampere meter shows current when capacitor bank breaker close?
What is dynamo function in DG sets and draw block diagram?
what is the purpose of high speed earth switch in gas insulated substat
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
what is subtransient , transient and steady stateac components
How to decide whether A / B / C / D curve type MCB should be used?
what is the function of capacitor duty contactor in an capacitor panel???
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
