Interested to Buy Any Domain ? << Click Here >> for more details...
Explain the working principle of Synchronous Generator and
Assynchronous generator?
- 11 Answers
- 54930 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / mahendra
synchronous motor runs at the speed Ns=120*f/p
it is not self starting because in the rotor the pulsating
e.m.f.is genrate due to this the motor doesn't run
| Is This Answer Correct ? | 3 Yes | 13 No |
Post New Answer View All Answers
what is the difference b/w ground & virtual ground?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
what is EIB lighting control system? what is the advantages of this system?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how desiel generate sart fail of eb?
What is expention fastener (Fan)
How LT megger works ?
What is the difference between Droop vs Isoch Control?
Define newton's law of viscosity.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
critically criticize the application of ring main unit in power system
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
How to improve fuel cell in a distribution system?
What is core CT & it's function?
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
