My question may be very basic or childish but this question
still persists in me, someone plz help me
1.why do we go for differential equations to analyze a system?
2.why do we solve it using matrices, is there any specific
reason for using matrices other than the stories like it is
simple,faster etc.
- 2 Answers
- 4965 Views
- I also Faced
- E-Mail Answers
Answer Posted / h v k kumar,mtech,instrumentat
if u model the any system like
mmechnical/electrical/pneumatic establish relation b/w
input and o/p force,mass,friction etc a=dv/dt,f=m(dv/dt)
model all forces and adding all forces we get diff equation
homo/non hom solve by using laplace trnsformation.but here
initial conditions assumed to be zero solution is state
space analysis using matlab ,so matlab variables are
arrngend matrix format.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
sir, give me placement papers and interview quistion of birla group company of copper.
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
please send data bank of quetions answers on analytical instrumentation.
give me all the details about the interview and which type of question being asked
principle of dead weight tester ?
send me last 5 years questions asked in rrb chennai, for section engineer
Questions on flow meters,few questions on HART protocol,
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
can any send me a forbes marshall dtron 316 manual
