Answer Posted / jigar parikh
power factor can be define as the all type of (induction
motor) load as inductive load has lagging power factor and
due laggin power factor will increase the current which
will cause the losses .. so that power factor should be
nearly unity.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
how harmonics generated in induction furnance? how minimise it?
what is earth pit , how we can measured it, what earth rods reference
what are the steps involved in generator load test?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
how could we calculate the no of outgoings from a 800 watt distribution board
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
Can Anyone suggest the Standards (IEC or IS) for selecting copper current density?
can u describe the method used for protection of transmission line.
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
what kvrah y we need to take the readind of that
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
