what is purpose of using reactor in substations.
Answer Posted / gunasekaran
there r 2 type of reactor
1.parallel reactor using to reduce the ferranti effect.
2,series reactor to limit the fault current.
| Is This Answer Correct ? | 85 Yes | 9 No |
Post New Answer View All Answers
I want to know the 'Test voltage' for Tandelta testing of 3.3 / 6.6 / 11 KV Motors. Please explain
A 3-phase IM is supplied from 50 Hz system. It runs at speed of 1440 rpm and slip equal to 4 %. Calculate number of pole pairs. A 1 B 6 C 2 D 3
Rules and standards of electrical control wiring ?
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
how to carried out tan delta test in 11 KV alternator ?
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
What is block diagram?
Haw to check conductivity of budbar
How will you utilise electrical power? You can start from the generating station.
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
in dc series motor if field wdg is shorted then
For overhead protection we use which transformer?
What are the specifications for conducting earth leakage test as per IEC standard?
for what voltage will reactive power be largest in 380 kv line : a) 375kv b)380kv c)385kv