please send jindal steel and power model question papers
- 61 Answers
- 55520 Views
- Jindal, Jindal Steel and Power, MeritTrack, I also Faced
- E-Mail Answers
Answer Posted / ankit jain
please send me any data regarding jindal paper....please....
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Define steam turbine diaphragm?
What are the automatic tripping devices of diesel generator?
What is the relationship between hardness and tensile strength?
• What is your weakness?
i want to know what r the various job in government as well as central government, for mechanical engineers. can any one answer plz
which quality steel is better for molasses storage tank? & why? IS 2062 GR A OR IS 2062 GR B
please send me rrb question papers of SE MECHANICAL
How much pressure on air reservoir?
what is line balancing
Define Grashof number and its significance?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
hii sir. how will CAE/CFD courses useful to B.tech freshers? is this courses useful to getting job in automobile industry? plz give some advise...
What ill be the shaft diameter with clearance having a bearing bore is 30mm?
How can heat be applied to acrylic?
What are the procedures on how to anneal?
