wat will be the pressure maintained inside the transformer?
Answer Posted / gunasekaran
For filtration we are maintain 765mm mercury vaccum
pressure is maintain.for tank testing we are maintain 6 bar
pressure and check the tank healthiness.but it is operating
atmospheric pressure only
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why we used ZNO in Lightning arrester.
can u tell me the promotion from oiller to enginer
if sf6 gas low in gis what will happen
What is the necessary and sufficient condition for stability.
How much minimum insulation required between 11kv/3.3kv transformer windings?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How do we calculate the Out put voltage of generator, after the excitation is being given?
What are the advantages of autotransformer?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
what is the calculation formula for motor starting torque,running torque, running torque.
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
What are the main advantages of generalized error co-efficients?