Interested to Buy Any Domain ? << Click Here >> for more details...
which is heavier 1kg. of iron or 1kg. of cotton?and why?
- 33 Answers
- 108354 Views
- Getco, Jindal, Lloyd, Naval Academy, NDA, samr, swiggy, I also Faced
- E-Mail Answers
Answer Posted / lallu lal
same.
| Is This Answer Correct ? | 162 Yes | 99 No |
Post New Answer View All Answers
What are the different types of gate valves?
is there a future for a mechanical er. in supplier development field ?
Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards
What does a pump develop? Give reason to support your answer.
describe a type when u anticipated potential problems and development of preventive measure.
What are the thermal conductivity properties of brass?
Do you receive good benefits as an engineer job?
how exact reduced the work done by compressor by use of intercooler?
What is heavy water and what is its use in nuclear plants ?
working of nuclear power plant
Can we integrate the C programming with Pro-e (modelling software)through application program?
What causes crankcase explosion?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
are BS, BSP, BSW threads same?
Tell me on steel
