Why don't we provide SURGE ARRESTORS for Transformer
feeders?
Answer Posted / gunasekaran
normally transformer insulation at beginner winding more
(thicker) than motor are other equipment so surge ac cure
due to the current zero is not damaging the winding so don't
want use surge arrestor
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Difference between transition and diffusion capacitance
What is center gravity load in substation?
What are unstable systems?
Which cable is use for rtcc control panel
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
What is resonant frequency?
Define demand factor?
1 Ton is equal to how many watts?
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
what the principle of sincroscope?how it works?when it needed?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What is different between Difnit time and instatous over current relay
Hello seniors m an engineering student in 3rd yr..i want to know what are the software course in electrical field?i wanted to do certification course but i dont know much about the course?..Regards
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is Surge Capacitor? Why it is use in Generator Circuit Breaker?