Interested to Buy Any Domain ? << Click Here >> for more details...
Everybody Knows What is ACB, VCB but anybody tell me what is ST?
- 7 Answers
- 9484 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhaskar reddy
it may be meaning of st is small tension
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
can i use the six sigma method which is used in management area, in state estimation of power systems?
What is the Resposiblity of Electrical Utility Engineer
What is tan delta & PPM in transformer? and whats its IS value?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What are the different types of controllers?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
what is the purpose of silicon dropper used in battery charger?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
What consists of 2 or more thermocouples to be connented series?
how to flameproof electrical motor on the shaft?
Difference between RCCB, RCBO and ELMCB.
how the B-H loop obtain under the static condition
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
