Answer Posted / pjagan89
the ABILITY TO DRAW WIRES is CALLED DUCTILITY.
Malleability is the ability to draw wires into thin sheets.
Answer: DUCTILITY
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
what is composition for cast iron as per is 120 grade 25
Differentiate between the uniform flow and non-uniform flow?
Is the hvac machines are designed 10% less than the electrical feeder value?
hi this is ravi , i was short listed in hal assistant engineer, now im going for interview can anybody help how is the interview for mechanical stream very urgent if anybody knows forward to me my mail id i.ravibabu2@gmail.com
What causes hardness in steel ? How heat treatment alters properties of steel ?
Would you please provide me with questions collected for interview regard to pressure vessel, which is in the aspects of welding, NDT, materials and painting? Please send these questions&answers to lgx_jasmine@126.com within 1 week, Thank you for your help. Rgs!
What is process flow diagram?
What is the mathed of maintain oxizen level in a air tite A/c room.
What are different types of gate valves?
what is the responsibility of assistant manager in welding in goa shipyrad company?
What parameters to be reported when we send lubricating oil for shore analysis?
The lowest allowable insulation resistance?
Titan Mechanical Engineering Interview Questions
Is there significant affect on the output of modern gas turbines due to low frequency.
What is shearing?
