what is the use of vacuum balancing valve in CEP
Answer Posted / shubankar sen
for maintaining the proper vacuum
Is This Answer Correct ? | 5 Yes | 21 No |
Post New Answer View All Answers
What type of gear is the first reduction gear pinion?
What is elasticity?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
Define heat transfer?
What is the power requirement of a refrigerator?
rrbchennaimodel question paper for current papers
Please tell me the difference between EN31 and OHNS material.
why desuperheater tubes are bend in shape
In order to derive the torsional formulas what are the assumptions taken?
I m having skype interview with germany team what are the common questions asked?
What will you do when scavenge fire happened?
I HAVE SELECTED INTERVIEW FOR GOVT POLYTECHNIC LECTURERS.I DONT KNOW ANYTHING.PLZ HOW INTERVIEW WILL GO AND WHAT QUE'S SUPPOSE TO ASK ABOUT SUBJECT.PLEASE SEND QUE'S AND ANSWERSTO MAIL OR CALL THIS NO:9966924990.PLZ HELP ME.
what is the relation between pressure&veloscity? give me one practical example?
What is a process flow diagram?
What are the items to inspect after cylinder liner is pulled out